DeLong’s manual gizzard peeling rollers have a unique, patented design to remove unwanted membranes and skin on any poultry gizzard quickly and efficiently. We manufacture these rollers to meet and exceed USDA approval codes, in a variety of lengths, constructed of stainless steel, and hardened stainless steel. Manual peeler rollers are available for all types of repeel stations.

Manual Gizzard Peeling Rollers

Note: Use the guide above and table below to ensure the proper measurements.
A: Peel Length
B: Peel Diameter (bushings)
C: Shaft Length (drive)
D: Shaft Diameter (bushing)
DeLong’s Part Number | Peel Length (A) | Peel Diameter (B) | Shaft Length (Drive) (C) | Shaft Diameter (Bushing) (D) | Drive Shafts on Both Ends | Reverse Gear on End of Peel |
---|---|---|---|---|---|---|
001 (Ashley) | 6 1/4 in. | 7/8 in. | 3 in. | 1/2 in. | ||
002 | 9 in. | 7/8 in. | 3 in. | 1/2 in. | ||
003 | 7 1/2 in. | .830 in. | 3 in. | 1/2 in | ||
034* | 10 in. | .810 in. | 3.50 in. | 1/2 in | ||
004 | 10 in. | .830 in. | 3 in. | 1/2 in. | ||
005 | 12 in. | 7/8 in. | 3 in. | 1/2 in. | ||
0067 | 12 in. | 7/8 in. | 3 in. | 5/8 in. | ||
067D | 12 in. | 7/8 in. | 3.5 in. | 5/8 in. | ![]() | |
067DRA | 16 in. | 7/8 in. | 3.5 in. | 5/8 in. | ![]() | ![]() |
0067R | 12 in. | 7/8 in. | 3.5 in. | 5/8 in. | ![]() | |
0067RA | 16 in. | 7/8 in. | 3.5 in. | 5/8 in. | ![]() | |
008 | 10.25 in. | 7/8 in. | 3 in. | 1/2 in. | ||
008D | 10.25 in. | 7/8 in. | 3 in. | 1/2 in. | ![]() | |
800F* | 10.225 in. | 7/8 in. | 3.10 in. | 7/8 step to 1/2 in. |
*Flats & Keys on Drive Shaft instead of Keys
All Rollers are available in Stainless Steel or Tool Steel
Bushings
DeLong’s recommends replacing your brass bushings every time you replace your poultry rollers. DeLong’s stocks all sizes for the end block application.
New brass bushings are always recommended when replacing any rollers. Bushings effect a rollers performance tremendously. Bad bushing can cause a good roller to perform poorly. DeLong’s stocks all sizes of bushings for any end block application.
DeLong’s Part Number | Description |
---|---|
0045AS | 1/2″ flange bushings |
0067AS | 5/8″ flange bushings |
FL5210 | 1/2″ flange bushings |
